TubingThe high pressure tube is used to transport the high pressure water from waterjet pump to the cutting station.High press...
232021-02
Weep HolesHigh pressure seals and connections fail gradually and begin leaking slowly. Weep holes are located at every thread...
232021-02
Pneumatic control valveFor reliable operation, the valve seat, seal assembly, brass support ring and valve stem should be replaced at the same ...
232021-02
Bearing ring and seal assemblyRemove piston plunger Use a flat, blunt-edged blade made of brass or similar soft metal materials to remove the tw
232021-02
Hydraulic PistonThe two bearing rings pass through the anti-wear contact surface between the piston and the inner diameter wall of the h...
232021-02
Disassembly of the piston plungerThe following operating procedures apply to the removal of the piston rod. Before removing the power source or any high-
232021-02
High Pressure Seal AssemblyThe following operating procedures are suitable for replacing high-pressure sealing components. Depending on the diamete...
232021-02
Sealing HeadSealing Head is sealed to the outer end of the high-pressure cylinder by a 45 metal-to-metal seal. The preload locating ...
222021-02
HP Cylinder Assembly WIN-WIN Waterjet recommends that if the plunger, high-pressure seals, hydraulic pistons, and sealing sleeves are to be r...
222021-02
High Pressure Tube and Low-Pressure Tube Before performing any maintenance on high-pressure components, be sure to remove the high-pressure tube and the low-pre
Intensifier pump maintenance processThe low pressure water flows through the inlet water port into the inlet path in the sealed compensation ring assembly.W...
202021-02
Maintenance of motor-Intensifier pumpWhen the elastic coupling fails, the intensifier pump shaft will not be able to rotate and the pressure will not be gene...