Waterjet Cutting Machine Common Troubleshooting
Fault | Causes | Solutions |
Computer parameter is not suitable | Check parameters | |
Servo voltage instability type phase deficiency | Check servo drive connected circuit | |
Drive failure | Follow drive error prompt to find | |
Driver no pulse input | Check the turnboard to the drive line | |
Copy file error or graphic exception | Software driver has data loss | Open the graphic using your computer, or re-open the software |
Host failure | Replace the host | |
X-axis direction error | The distance from the cutter head to the cutting material is different. | Investigation of the grille, re-guarantee the blade to the material surface |
Y-axis direction error | The distance from the cutter head to the cutting material is different. | Investigation of the grille, re-guarantee the blade to the material surface |
X and Y axis are not vertical | X-Axis and Y-axis dislocation | Adjust the Y-axis belt so that it is perpendicular to the X-axis |
Operation Interface Alarm | Refer to users manual | |
Small deviation in cutting accuracy | The cutting head is not vertical to the cutting material or the distance between the cutting head and the cutting material surface is different during moving | Re-adjust the perpendicularity of the cutting head or adjust the grid bar to make the distance between the cutter head and the surface of the cutting material during the movement |
